Cummins R2.8 Turbo Diesel Engine with Toyota H55 & H42 Manual Transmission Adapter Kit
- New 4 cylinder Cummins R2.8 Crate Engine (Part#5467046)
- Adapter works with the Toyota 4 speed H42 and 5 Speed H55
- Bell housing bolts the transmission directly to the engine
- Designed to work with External Slave CS2326 ( 1998 Jeep Wrangler .75" bore)
- Utilizes an OEM Clutch part# KF593-01 (10.75" OD, 10 Spline 1.0938" ID
- Need Factory Toyota T.O. Bearing Hub (Part# 31231-60070)
- Designed for Toyota Transmissions with 10 Spline 1.1" input shaft
- Direct bolt up to 1998 Jeep Wrangler Slave cylinder (External Hydraulic)
- Engine carries a 2 year 2600 hour warranty covered thru Cummins (Buyers in USA ONLY)
- Due to Emission regulations, engine must be installed in vehicles 1999 or older, will require VIN at purchase
- R2.8 Engine is not supported under warranty for Buyers outside of the United States
- Kit# EN-00002
Parts included in Kit:
| QTY | Description | Part# and Location |
| 1 | Cummins 4 Cylinder crate engine | 5467046 |
| - | Complete Front-end accessory drive | |
| - | Vacuum Pump | |
| - | Remote fuel/ Water separator | 5268019 |
| - | Remote Oil Filter | 5308354 |
| - | Remote Oil Filter Manifold | 5209233 |
| - | Mass Air Flow Sensor and Housing | 4984760 |
| - | Engine Wiring Harness and ECM | |
| - | Starter | |
| - | Universal Wiring Harness | |
| - | Throttle Pedal | |
| - | Oil Fittings | |
| - | J1939 Can Dash Display | |
| - | Owners Manual | |
| Installation Guide | ||
| 1 | Bell Housing | QDB-210111 |
| 1 | 9 hole Flywheel | QDB-210132 |
| 1 | Flywheel bushing | QDB-210124 |
| 1 | T.O. Fork | QDB-210125 |
| 1 | T.O. Fork Retainer | QDB-210001 |
| 1 | 5/16-18-.75" | Hex Head (Fork Retainer) |
| 1 | 5/16 Lock Washer | (Fork Retainer) |
| 4 | 1/2-13x1.5" | Hex Head (Bell to Trans) |
| 4 | 1/2 Flat Washer | (Bell to Trans) |
| 1 | Pivot Ball | 52087542 |
| 9 | 5/16-18x1.0" | Hex Head (Clutch) |
| 9 | 5/16 Lock Washer | (Clutch) |
| 12 | M10x1.5x40mm | SHCS (Bell to Engine) |
| 12 | M10 SAE | Flat Washer (Bell to Engine) |
Dimensions:
Length from Harmonic Balancer to rear face of Bell Housing: 31.25"
Weight: 685lbs
