Adjustable Manual Transmission Pivot Ball
- Allows for adjustment of clutch fork angle
- Easy to install and adjust
- Install bell on engine w/ clutch, pivot ball, t.o. bearing, and fork
- Leave transmission off bell
- Run the pivot ball bolt in or out so that the opposite end of fork is around .560" to .625" from edge of bell housing machined face as shown in image. This measurement is only important to keep the clutch fork away from the bellow/ flange of the slave cylinder.
- Using provided washers stack them between pivot ball and bell housing
- hand tighten ball so shims are snug, tighten bolt head, then tighten jam nut
- Install transmission and double check distance from fork to bell
- Works will all Quick Draw Brand Bell Housings
- Theaded shaft is 3/8-16"
- Kit Number MN-00005
- Made in the USA
Parts included in Kit:
| QTY | Description | Part# |
| 1 | Pivot Ball Tip | QDB-220124 |
| 1 | 3/8-16x3.5" Full Thread Grade 8 Hex Bolt | 92620A638 |
| 1 | 3/8-16 Jam Nut | 94895A031 |
| 11 | Shim (M10 Flat Washer) | 98688A118 |