Cummins R2.8 Turbo Diesel Engine with Jeep AX15 5 speed Manual Transmission
- New 4 cylinder Cummins R2.8 Crate Engine (Part#5467046)
- New Jeep Aisin AX15 5 speed 4x4 Manual Transmission
- Bell housing bolts the transmission directly to the engine
- Engine carries a 2 year 2600 hour warranty covered thru Cummins
- Due to Emission regulations, engine must be installed in vehicles 1999 or older, will require VIN at purchase
- Kit# EN-00005
Parts included in Kit:
| QTY | Description | Part# and Location |
| 1 | Cummins 4 Cylinder crate engine | 5467046 |
| - | Complete Front-end accessory drive | |
| - | Vacuum Pump | |
| - | Remote fuel/ Water separator | 5268019 |
| - | Remote Oil Filter | 5308354 |
| - | Remote Oil Filter Manifold | 5209233 |
| - | Mass Air Flow Sensor and Housing | 4984760 |
| - | Engine Wiring Harness and ECM | |
| - | Starter | |
| - | Universal Wiring Harness | |
| - | Throttle Pedal | |
| - | Oil Fittings | |
| - | J1939 Can Dash Display | |
| - | Owners Manual | |
| Installation Guide | ||
| 1 | 5 Speed Transmission | AX15 |
| 1 | AX15 Transmission Shifter | |
| 1 | Bell Housing | QDB-210115 |
| 1 | T.O. Bearing | N093SA |
| 1 | Clutch Fork | 53006388 |
| 1 | Pivot Ball | 52087542 |
| 1 | Fork Retainer | 4338855 |
| 1 | Flywheel | QDB-210109 |
| 1 | Flywheel Insert | QDB-210018 |
| 1 | Flywheel Pilot Bearing | QDB-220050 |
| 12 | M10-1.5x40mm | SHCS (Bell to Engine) |
| 12 | M10 SAE Flat Washer | (Bell to Engine) |
| 2 | 5/16-18x1.25" | Hex Head (Slave Cylinder) |
| 2 | 5/16 Flat Washer | (Slave Cylinder) |
| 2 | 5/16 Lock Washer | (Slave Cylinder) |
| 6 | 3/8-16x1.0" | Hex Head (Clutch) |
| 6 | 3/8 Lock Washer | (Clutch) |
| 1 | 10.5" 1.25" dia 10 spline Clutch Kit | 05-065 |
| 1 | Slave Cylinder | QDB-220045 |
| 1 | Slave Cylinder Fitting | QDB-220046 |
Dimensions:
Length from Harmonic Balancer to Rear face of Transmission: 48.75"
Length from Harmonic Balancer to center of shifter: 44.75"
