Engine and Adapter- Cummins R2.8 Crate engine & Land Rover R380 Adapter Kit (300TDI)


Complete package with New Cummins R2.8 crate engine and bell housing adapter kit for 300TDI R380 Land Rover transmission



Cummins R2.8 Turbo Diesel Engine with Land Rover R380 5 speed Manual Transmission

  • New 4 cylinder Cummins R2.8 Crate Engine  (Part#5467046)
  • Adapter works with 300 TDI Version 5 Speed
  • Bell housing bolts the transmission directly to the engine
  • Designed to work with Mopar Small Block 10.5″ 23 Spline clutch kit Part# 05029
  • Best fits 4 cylinder Defenders which were built before the 1993 floor change over
  • Engine carries a 2 year 2600 hour warranty covered thru Cummins
  • Due to Emission regulations, engine must be installed in vehicles 1999 or older, will require VIN at purchase
  • Best performance with a 1.2 ratio Transfer Case
  • Kit# EN-00013

Parts included in Kit:

QTYDescriptionPart# and Location
1Cummins 4 Cylinder crate engine5467046
Complete Front-end accessory drive
Vacuum Pump
Remote fuel/ Water separator5268019
Remote Oil Filter5308354
Remote Oil Filter Manifold5209233
Mass Air Flow Sensor and Housing4984760
Engine Wiring Harness and ECM
Universal Wiring Harness
Throttle Pedal
Oil Fittings
J1939 Can Dash Display
Owners Manual
Installation Guide
1Bell HousingQDB-210147
1Bell Housing SpacerQDB-210148
2Bell Housing DowelQDB-210074
1T.O. Bearing SnoutQDB-210084 (Press in Bell Spacer
1Pivot Ball5287452
1Flywheel InsertQDB-210017
1Clutch ForkQDB-210123
1Clutch Fork RetainerQDB-210001
1T.O. BearingUTJ10021
1Pilot BearingQDB-210059
1Slave CylinderQDB-220045 (1998 Jeep .75″ bore)
1Slave Cylinder FittingQDB-220046 (-3AN)
35/16-18×1.0″SHCS (Snout)
15/16-18x.75″Hex Head (Fork Retainer)
35/16 Lock Washer(Fork Retainer & Slave Cylinder)
25/16-18×1.25″Hex Head (Slave Cylinder)
25/16 Flat Washer(Slave Cylinder)
5M12-1.75x180mmSHCS (Bell to Trans)
1M12-1.75x160mmSHCS (Bell to Trans)
6M12 Flat Washer(Bell to Trans)
12M10-1.5x40mmSHCS (Bell to Engine)
12M10 SAE Flat Washer(Bell to Engine)
63/8-16×1.0″Hex Head (Clutch)
63/8 Lock Washer(Clutch)


Length from Harmonic Balancer to rear face of Transmission: 48.5″

Weight:  685lbs

Additional information

Weight1150 lbs
Dimensions48 × 40 × 45 in